Before posting any more pics I want to know if there are still people reading this thread, cause if no one is reading it anymore there's no reason for me to keep posting updates here...
It took me more time than I imagined to drill all the holes for screws and hose fittings because (besides copper being a bitch to drill) as I said before this batch of blocks are all 1 or 2mm wider on one side so it's hard to measure and determine the exact places for the holes in a irregular piece, also I got a cut in my hand from a top that "grabbed" the driller and started spinning like crazy, to avoid that and make the drilling process a lot faster I'm putting together something that will hold the tops (and the blocks) in the right spot in the table top driller.
I should have the C/W numbers in the next couple of days.
Bruno Facca
|