Well.. looks like the heat is normal for the CS pumps when they encounter any back pressure:P Will need to add a fan infront of the motor to cool it down a bit.
While installing the waterblocks though I ran into something of a problem.. No holes around the chipset
Just 2 loops as you can see...
I can either: 1) try to make something that will be similar but higher to work with my Z chipset block
2) Clip off the hoops and drill 2 holes into the pcb where they are to install it the way it is supposed to be installed..
Any problems with #2?
PS. IT7 MAX2 mb