Pro/Forums - View Single Post

MadDogMe · 10-09-2002, 10:39 AM

Yep, I meant as in the four mounting(AMD) holes, which are centred in their way I s'pose.

I don't know if the performance was adversly affected, but there was just some kinda oily residue left on most of the core area. all(well, most) of the 'silver' had moved to the edge or beyond.

I might have put it on to thick (even by my 'thin' standard), I could imagine this exagerating the problem now I think about it. to much volume of oily stuff allowing the silver to migrate???...

Can you get torque drivers that go down to that lbs with a good 'resolution'(degree of acuract). or is that overkill?. when that fine a measurement the drag on the thread or spring snagging would throw it out would'nt it?. or is 6lbs quite hefty?...

10-09-2002, 10:39 AM	#9
MadDogMe Thermophile Join Date: Aug 2002 Location: Just shut up ;) ... Posts: 1,068	Yep, I meant as in the four mounting(AMD) holes, which are centred in their way I s'pose. I don't know if the performance was adversly affected, but there was just some kinda oily residue left on most of the core area. all(well, most) of the 'silver' had moved to the edge or beyond. I might have put it on to thick (even by my 'thin' standard), I could imagine this exagerating the problem now I think about it. to much volume of oily stuff allowing the silver to migrate???... Can you get torque drivers that go down to that lbs with a good 'resolution'(degree of acuract). or is that overkill?. when that fine a measurement the drag on the thread or spring snagging would throw it out would'nt it?. or is 6lbs quite hefty?...