Silly me I completly forget water temps. those average max. temp are normalized to 20°C water, so the differences are only from design and flow rate.
Well no temps for Magnum, why ? Because it's mounting mechanism sucks, and I manage to burn my old 1700+ ,because the springs wasn't strong enough for good contact between block and core, so when I start up at 1950@2,1V cpu just died.
With new cpu I was a little more carefull, and started at default setting 1600+ 1.75V , and then slowly raised the clock, but again cpu just become unstable even at 1700Mhz, and the temperature was pretty normal for that clock, so like I said one part of the block was in contact and some part wasn't so I just gave up, because I'm not made out of money to just burn those cpu's.
As for fittings all block were mounted the same 1/2 od 8mm ID brass fitting, except for Magnum which was 6mm ID. Oh yeah the Magnum is one spiral chanell milled just for info
|