The Mag-Drive pump needs 1/2 Male IPS thread X 3/8 Barb, and a 1/2 Female IPS thread X 3/8 Barb. Also get 1/2 teflon tape, and apply 5 full wraps. Won't leak. Be careful when tightning, hand tight then 3 turns with a wrench. Sizes does matter here, so don't a 18" pipe wrench, use a small cresent or channel locks. If you crack the pump housing, see the Pro Cooling Mag-Drive guide.
__________________
Went to smoke crack.....Be back in 3 days
|