BigBen!, how are you planning on doing the outlet?, like a two in one pipe?(like phase change, inlet inside outlet). it'd be difficult but doable. I'd alter the size of the holes around the circle of my design to balance out the flow, to allow for the offcentre outlet. but I'd like to try to incorporate the 'two in one' idea into my design as well(no need to alter hole size for balancing flow
).
Or were you planning on multi outlets?...
*edit*
Quote:
|
There would be a 1 7/8 inch copper tube soldered to the top, for the 1 7/8 ID vinyl tube. The center inlet is fed from a 1/2 inch tube that's inside the big tube.
|
Read it properly this time
, I still can't visualise the 'cube res' part, are you gonna carry the two pipes all the way to the res/pump without seperating them?. you could make a seperator that fits to the block yes?, is that the 1 & 7/8 Cu tube thing?.
PS. I think I got the Res thing now, you don't have to submerse the pump either do you!!, just use the res to 'separate' the two tubes
, Kudos!!...
It's very simular to what I had in mind, except you took it further with the two in one pipe
. the second pic of the 'slots' in a circle, they're the outlets from the main block chamber yes?,are you gonna use Cu to go on top of that?, or Plexi?(you could use plexi tube to attatch the 1&7/8 tube to, on the top plate. and 1/2 tube attatched to the 'slot' plate) to keep the weight down, I'd use plexi for the plate with slots in as well, make for a cool visual experience as well
...