Quote:
|
morphling1 bb2k, I thought of this idea long time ago, when I first think od radial design block, but it's not that simple to implement, somewhere on that line you will have to separate those to lines and for that you will need special piece like a block where that hose and a hose within come and then separate, plus the solution on the block isn't too simple either. Good idea but hard to implement, especialy to look like an end product not some gheto mod.
|
You could do it by having a reservoir with a 1&7/8 barb one side and a 1/2 bulkhead fitting the other(plus a normal 1/2 barb for the block outlet/res to vent from), the 1/2(block in) tube would carry through the 1&7/8 barb to the bulkhead fitting then on to the pump outlet, the 1&7/8 tube would empty into the reservoir. Ta~Da!
...
Was this what you had in mind BB2K?, or were you going to make a more exotic reservoir?. I'd be interested in other ideas you had, even scrapped ones.(how many people have scrapped a 2Tube aproach?, I did, passed over it in a few seconds as unworkable
)
I did'nt realise you were going for plexi from the pic. (it takes me a while to realise whats what sometimes without pics and BIG LABELS :shrug
I thought it was so you could see detail underneath
...
PS. do you think there's a way you could implement multi in/outlets like BRs with this aproach then?...