View Single Post
Unread 10-19-2002, 11:33 AM   #1
master_akira
Cooling Neophyte
 
master_akira's Avatar
 
Join Date: Sep 2002
Location: Baton Rouge, La
Posts: 5
Default Titanium Drill Bits

I am planning on making a cross-drilled (xjinn sp?) water block out of copper for my future water-cooling system. I have recently purchased a box of titanium drill bits at a steal ($30). I am planning on using the drill press pictured below. Do these bits look like they will cut it (pun intended) or should i go with titanium bits from a company like dewalt that cost $25 for a lot fewer bits that might be higher quality. Thanks

master_akira is offline   Reply With Quote