Pro/Forums - View Single Post

bigben2k · 10-21-2002, 01:01 PM

No, it's two cuts no matter what. It would involve a third cut to take it out.

Refer to the colored drawing: there is one cut on each side of fin set #4 (red). Since the cut is 1.0 mm wide, the result is fin set #5 (the posts).

10-21-2002, 01:01 PM	#100
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	No, it's two cuts no matter what. It would involve a third cut to take it out. Refer to the colored drawing: there is one cut on each side of fin set #4 (red). Since the cut is 1.0 mm wide, the result is fin set #5 (the posts). __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101