Quote:
Originally posted by Axly
Cut a number of pieces like those seen in the picture.
Stack them as shown in picture.
Tighten the pieces together with bolts placed through the 4 holes.
Silver-solder the edges.
Drill holes for in- and outlet.
Sand and polish.
Fasten the hose-barbs.
Ofcourse you need a whole piece on each side as well, and preferrably with a bit thicker copper that will help holding the block together during soldering.
|
This is, in fact, exactly the way that CaMMo does his implementation of sciencewhiz's "Lamiflow" design.
http://cammo.kangaweb.com/design.html
but with the barbs coming in at a tilted angle.