View Single Post
Unread 10-12-2001, 05:19 PM   #1
redleader
Thermophile
 
Join Date: Jun 2001
Location: The deserts of Tucson, Az
Posts: 1,264
Default Stupid question: Is it I.D. or O.D. ?

Basically, I can't remember how this works. My system uses 1/2 inch fittings. Does this mean my Maze2, DTek core and Eheim use 1/2 inch OD, while my 1/2 inch tubing from DangerDen is 1/2inch ID?

Or are they all the same size and the tube simply streches over the fittings?

I ask because I'm getting ready to replace my entire system with compression fittings and a nice new double-tap bleed line and I need to make sure all the fittings I get will be able to work with each other and my current hardware.

Thanks.
redleader is offline   Reply With Quote