Quote:
Originally posted by utabintarbo
It's very pretty. However, I would recommend extending the fins around the first bend (assuming a center inlet) and over the core. That is where they will do the most good, IMO.
Bob
|
I wanted to do that, but i just dun have the skills in Solidworks to draw it out evenly.
Quote:
Originally posted by MadDogMe
The stuff on the right(specialy single outer channel, and the 'semi circle' thing) is'nt doing anything really, also have the channel the same width as the in/outlet 'circle'. I think you'd be better of with a multichannel 'spiral', I'm not into spirals myself, I think Cathars got the right idea putting fins over the core area, it's wasted elsewhere IMO:shrug: .
Why the three holes in each corner?, thinking of making it a TEC block?, if so fins everywhere over the TEC area is the way...
|
the semi-circle thing at the center is just for filling up the empty space. I was actually thinking of a multi channel spiral before i set off designing this, but my "leet" SolidWorks skills really is restricting my designs alot
The 3 holes in each corner is not for TECs. The middle hole is for the Socket A's mounting holes, the 2 outer holes are for mounting the lexan on top of it.
Any more comments?