Pro/Forums - View Single Post - Will the maze 3 work for me? (fitting issue)

icel0rd · 10-22-2002, 12:15 PM

Hm, they just might be solder covered holes, but I'm going to check again when I get back home.

I see photos of the same board and it has holes for mounting... I'm going to take a closer look at it later on tonight.

I didn't have it in front of me when I posted the distress beacon, but I'd swear that there were no holes because I remember checking... Before I go on anymore about this, I'm going to look again closely.

If they are solder covered, do you think it's safe to open the holes? That may be why I didn't see them. I guess any other drilling is out of the question.

Ice

10-22-2002, 12:15 PM	#5
icel0rd Cooling Savant Join Date: Jan 2002 Location: Where even the devil wont go Posts: 103	Hm, they just might be solder covered holes, but I'm going to check again when I get back home. I see photos of the same board and it has holes for mounting... I'm going to take a closer look at it later on tonight. I didn't have it in front of me when I posted the distress beacon, but I'd swear that there were no holes because I remember checking... Before I go on anymore about this, I'm going to look again closely. If they are solder covered, do you think it's safe to open the holes? That may be why I didn't see them. I guess any other drilling is out of the question. Ice __________________ Redhat 8 Gigabyte GA-7dpxdw+ w/dual modded AXP 1800+ CPUs running at AXP 2000+ speed 1 512 meg crucial ECC DDR 2100 1 512 meg Infineon PC2700 Sblive Value Geforce 4 Ti4600 Deskstar 60 gig drive (1)K4.1 waterblock (.5" barbs) (1) Maze 3 waterblock (.5" barbs) Black Ice Rad TopFin 250gph pump 1/2" OD Vinyl hose (yep, vinyl)