Pro/Forums - View Single Post - For those interested in a Swiftech like Bleed system w/ 1/2" ID...

dantheman · 10-15-2001, 03:26 PM

I thought about doing just that. . . but was didn't quite know how I was going to do that. I thought about drilling holes in the case, but then tryed to figure out how I would get that side of the case off. It is all stuck inside of an AT case, so it all pulls apart as one. Out side on one side was not an option. If I can get a 1/2 three way elbow, I will use that and mount it on the front.

10-15-2001, 03:26 PM	#8
dantheman Cooling Savant Join Date: Jun 2001 Posts: 152	I thought about doing just that. . . but was didn't quite know how I was going to do that. I thought about drilling holes in the case, but then tryed to figure out how I would get that side of the case off. It is all stuck inside of an AT case, so it all pulls apart as one. Out side on one side was not an option. If I can get a 1/2 three way elbow, I will use that and mount it on the front.