A further note on the quick disconnects:
I understand the restriction problem and am going to use oversize fittings. Also all cases are using bulk head fittings with 1/4 NPT thead size. I understand I may have been better off to use 1/2 inch NPT but case room wont allow it unless I attach them into the side panel ( not what I wanted to do).
Thank you one and all for your input, it at least makes me think I am headed in the right direction.
I hope to have the system completed in about 3 weeks, if all goes well I will post a summary and some pics.
one last thought:
do ya think braided steel line might be a bit overkill?? :P
Aardil
|