More questions from me
I have pretty much figured out everything I'm going to get for my watercooling setup. However, I'm still slightly confused on the bleed point thing since I'm going with a closed setup w/o a reservoir. I've made a diagram here (
http://www.josephgruber.com/netvista...ater_setup.png ). You can see it in relation to my case here: (
http://www.josephgruber.com/netvista...inside_top.png ).
I thought from what I was told before that was all I needed to do but last night I heard that about every 1-2 months I would need to replace the water in there. I would also need some way to get the air bubbles out.
What would be the best way to do this using my current setup? Where would be the best placement as well as what parts do I need? I figure from my aquarium I would just use a T joint that I could close off when running normal & then open when I needed to take the water out & put it back in?
As always any info is welcome & I appreciate all the help I have gotten here with this project!
