Quote:
|
It´s optimized for high flow speed over the whole surface by running a thin film of water through a narrowing channel as the radius increase. So it should be somewhat restrictive, but that’s the cost of high surface speed.
|
It was 'the narrowing channel' that got me!, I see what is meant now, the base get closer to the top at the outer edges...
Kudos for simplicity and complexity, if u know what I mean
...
Quote:
|
How was the base attached to the lathe while you were working on it? 4 screws? I might be able to use my drill press... muahahahaha!!!
|
L00N!!
, I use my Dremmel!
...