I take it most of you knowledgeable readers have seen my post about my dual water cooling system. This weekend I have been cruising the boards looking for info and think I may have spotted a major flaw in my system. I am using 2 brass tees and several brass elbows. If what I read is correct I would be better off using graduale (sp?) bends either out of hose or preformed out of copper tubing to lessen the restriction. Maybe soldier up a couple of "y" tubes to replace the Tees. Since I have already spent the money on the fittings I will go ahead with the original plan but wondering if you think doing the above would really make any noticeable difference? Dam dont even have the first ounce of water flowing and already planning to remake it
As always your input is greatly appreciated
Aardil