View Single Post
Unread 11-03-2002, 10:25 AM   #6
PolakATL
Cooling Neophyte
 
PolakATL's Avatar
 
Join Date: Oct 2002
Location: The ATL
Posts: 20
Default

226W woth a mean well 12v 25A supply. Keep in mind the temps are when its highly OCed and the IT-7 probe is known to register high temps. Although the pump is hit hard and the water has no pressure at all it just babrely flows.
with that out of the way I have a new problem.

MY BOARD WILL NO LONGER START. at first it was suffering from a cold boot problem were it always showed an A7 error in the mornings (i don't have the balls to run my setup un attended just yet). neways after i let it sit there for a minute or so and a few restarts later it would boot up fine and stable. then one morning it wouldn't boot at all after clearing the cmos same prob. then when i touched the cmos pins with the jumper it booted up with all my bios settings and it didn't need a jumper on the pins at all. this was the way to turn it on for 2 days and now its complete silence. there is no reofrom the board at all. NEone know what to do?
__________________
ABIT IT-7 MAX
P4 2.26B@3.01 1.7v 180fsb
Corsair (samsung) PC3200 C2
Radeon 9700Pro 3Dmark2k 16606
(384/350)
http://service.madonion.com/compare?2k1=4474405
60gig WD7200

H20> Maze 3, heater core, GeF4 on ATI, Via Aqua1300
PolakATL is offline   Reply With Quote