[mrbingley]

"MadDogMe"
Yes sorry for how it looks, I was in rush to get a picture up. The inlet (which I've just soldered in) to the res is level with the top of the shroud.
So the order is "bottom outlet of res - - pump inlet - - pump outlet - - inlet pipe of rad - - outlet pipe of rad - - waterblock inlet - - waterblock outlet - - top inlet of res". The water will circulate upwards in the rad to try and eliminate any air blockages & with the rad opening up to 18mm cross pipes & 15mm vertical pipes will slow the circulation slightly to allow the fans to extract a bit more heat.
I hope that makes it a bit clearer. I'm hoping to install it this weekend, so will post some pictures when I've done it.

Cheers
Chris.