Quote:
Originally posted by jaydee116
I was thinking about this very issue. I thought about making the outlets on the sides of the block instead of ontop of it. That way the water will go all the way down and then left and right into the outlets and then up instead of water hitting water already in the block and pushing out the nearest outlet wich is right next the to inlet. Did that make any since? 
|
the tabs sticking out the bottom of the middle plate were supposed to be for the purpose of making the water travel 1st in the direction opposite the barbs, then around the sides and under the tab, then into the outlets...
i'm not sure if it will work though or if it would hurt flow rate too much
EDIT: * and I kind of understand your idea about having side outlets, but i'm not exactly sure where you are talking about putting them. plus that might be bad for motherboard clearance, though the block size could get decreased...