Quote:
Originally posted by Albigger
the tabs sticking out the bottom of the middle plate were supposed to be for the purpose of making the water travel 1st in the direction opposite the barbs, then around the sides and under the tab, then into the outlets...
i'm not sure if it will work though or if it would hurt flow rate too much
EDIT: * and I kind of understand your idea about having side outlets, but i'm not exactly sure where you are talking about putting them. plus that might be bad for motherboard clearance, though the block size could get decreased...
|
I would drill the outlets into the block itself on the left and right sides. drill a hole strait down and then cross drill it from the outside and cap the hole. Also make the inside top to bottom clearance the same as the hole cross drilled or maybe a little narrower so the water is forced to the left and right out the side outlets. I will try to make a drawing sometime. Way to tired to mess with acad right now.
