Pro/Forums - View Single Post - Two pumps config

g.l.amour · 11-11-2002, 09:16 AM

i c

well, i'd like more to do it from a to z myself, but if it ain't possible for you, so be it.

what i also found at diy store , was a 45-90° saw on a standard. looked to be for aluminum profiles. but with a little patience i thk it could also be used to cut up the bars. anyway, that should eliminate the drifting u spoke about when trying to dimension the blox with a hand metalsaw.

shit puzzdre, in a couple of days, u will have new blox to show off. its been real nice of you to take pix all the way to the end. i learned alot. i know the original idea is rotor's; but his site provides essential info on the design, but this thread is basically a howto.

11-11-2002, 09:16 AM	#122
g.l.amour Cooling Savant Join Date: Mar 2002 Location: on da case Posts: 933	i c well, i'd like more to do it from a to z myself, but if it ain't possible for you, so be it. what i also found at diy store , was a 45-90° saw on a standard. looked to be for aluminum profiles. but with a little patience i thk it could also be used to cut up the bars. anyway, that should eliminate the drifting u spoke about when trying to dimension the blox with a hand metalsaw. shit puzzdre, in a couple of days, u will have new blox to show off. its been real nice of you to take pix all the way to the end. i learned alot. i know the original idea is rotor's; but his site provides essential info on the design, but this thread is basically a howto.