[pHaestus]

If you do decide to do this, then take a look at the holes around your motherboard. If they are of the smaller variety (like my Asus) then get 6/32 x 2" screws and some extra nuts. You can again use 2 nuts on the end as spacers, but after you put the screw through the Maze2 then add another nut and tighten it down. The 6/32 screws will fit easily through the motherboard holes and so you can just align all the screws and slide the block into place with the case standing upright. I was amazed how much easier this made things. It is really easy to get the block squarely mounted, and the springs have to be slightly compressed to fit on the 2" screws so as soon as you put a nut onto them they help keep the block mounted properly as you tighten it.