Quote:
Originally posted by Albigger
Notice the extened water cavity and o-ring. Also notice the pillars on the outer row are connected, and the hole in the middle of them is offset (i.e. its right in front of another pillar instead of an opening) Will this be enough to deter enough flow to the outside and around to the outlet - hopefully. The gap in that wall is only 1/16" wide, and I don't even have to mill it all the way down if I don't want.
|
It seems that a modification like this will make machining more difficult (not a lot, but some). You might want to reconsider milling the pillars at 45 degrees.
I would also take the sharp angles out of the outer corners.
Bob