Pro/Forums - View Single Post

Can O' Beans · 11-15-2002, 08:31 PM

I was considering making a center inlet. Had 1/2" of plexi to work with and figured I could make a wide & thin slot for the water to enter through.

For $16 US (Newegg), you could easily get a few of them & test with different numbers fins and if you had access to a mill, thin the baseplate out more.

If my uncle gets another machining job, I'm going to try to incorporate the 2nd one I have into a GF4 block - IF it will fit (don't have GF4 GPU & RAM dimensions)

11-15-2002, 08:31 PM	#9
Can O' Beans Cooling Savant Join Date: Aug 2002 Location: Pa - USA Posts: 264	I was considering making a center inlet. Had 1/2" of plexi to work with and figured I could make a wide & thin slot for the water to enter through. For $16 US (Newegg), you could easily get a few of them & test with different numbers fins and if you had access to a mill, thin the baseplate out more. If my uncle gets another machining job, I'm going to try to incorporate the 2nd one I have into a GF4 block - IF it will fit (don't have GF4 GPU & RAM dimensions)