Why on earth did'nt they stick with the central inlet?, and surely the bit in the middle is back to front?(upside down even?
), would'nt it have be better to
lower that centre 'S/Z' shaped bit?, to force water down into/over the core area?. instead of allowing a massive pressure drop?.
Also what's going to make the water flow in and around those pins?, won't it just go over them?...
How about ProCooling hosting BillAs work?, it's all relevant is'nt it?, even if some people find some of it a bit obscure. there are lot's of graphs I've never seen because my ISP won't access thermalmanagment.com, if I'm missing them I bet loads of other people are as well. also is there any reason that an article not be posted at OC & PC? simultaniosly, (at least at PC you can get questions answered in the forum, as long as you don't get banned again soon BillA
)...