Pro/Forums - View Single Post

sunblade · 11-13-2001, 07:45 PM

I have a maxi-jet 1200 that I want to use inline, but it has non 1/2-id fittings, and really no fittings at all, just stubby plastic tubes. What would be the best way to convert the fittings? One site talked of just getting screw-threaded fittings that were slightly smaller and making a groove in the plastic with the threading, then sealing it with goop. Would it just be easier to put the pump in a res? I could always put the pump before the heatercore so the extra heat doesn't reach the CPU.

11-13-2001, 07:45 PM	#1
sunblade Registered User Join Date: Jul 2001 Location: USA Posts: 156	Good way to convert fittings? I have a maxi-jet 1200 that I want to use inline, but it has non 1/2-id fittings, and really no fittings at all, just stubby plastic tubes. What would be the best way to convert the fittings? One site talked of just getting screw-threaded fittings that were slightly smaller and making a groove in the plastic with the threading, then sealing it with goop. Would it just be easier to put the pump in a res? I could always put the pump before the heatercore so the extra heat doesn't reach the CPU.