Pro/Forums - View Single Post

Antimatter · 11-28-2002, 02:46 PM

allright, i think i have decided on a design.

i like both the #rotor designs and the sprial design, so i am going to sort of combine both of them. the center of the cpu block is made using the #rotor method, and the rest is a spiral made with a drill press. i will dremel down the corners after drilling the holes. these are kind of rough picturs...

these will probably be made using 2" x 1.5" copper bars
the gpu block is attached to my gf4 4200 using the 4 little holes next to the chip, not the ones that the stock heat sink is mounted on (is this a good idea?)

CPU 2"x3.5"

GPU 1.5"x1.5"

any thoughts? i put up a post in the general watercooling forum about the rest of the setup here
thanks

11-28-2002, 02:46 PM	#10
Antimatter Cooling Neophyte Join Date: Nov 2002 Location: New England Posts: 43	allright, i think i have decided on a design. i like both the #rotor designs and the sprial design, so i am going to sort of combine both of them. the center of the cpu block is made using the #rotor method, and the rest is a spiral made with a drill press. i will dremel down the corners after drilling the holes. these are kind of rough picturs... these will probably be made using 2" x 1.5" copper bars the gpu block is attached to my gf4 4200 using the 4 little holes next to the chip, not the ones that the stock heat sink is mounted on (is this a good idea?) CPU 2"x3.5" GPU 1.5"x1.5" any thoughts? i put up a post in the general watercooling forum about the rest of the setup here thanks __________________ Asus A7N8X Delux Athlon 1700+ 512MB Crucial PC2700 XFX Geforce 4 TI4200