Why not add a psi guage into the line instead? Have at first only the guage and say 1.5m of tube in a loop, this will give you a base line reading. NOw add a rad and take a second reading. Then as you add each part of your system you see the growing pressure and know where it's coming from.
Or for testing WB only. Once the above set up is made and you switch WB at any point then the change in psi will show if the differant block has higher or lower pressure than the one it was subed in for.
And you don't need any tall tubes at all.
Now someone show me why this is screwed up please. I'm new but this seems like it should work, to easy but I can't see the fault.
|