Quote:
Originally posted by jamicon
if you have a 1/2" system, use 1/2", if you have a 3/8" system, use 3/8"
unless the channels will be rounded
(eg like this)"
in which case you could use a smaller pipe diameter (as it would create better velocity, but not have corners to slow it down)
thats my $0.02
|
well i won't be able to make them round (to much work on a manual mill) but it will not have 90* corners, they will be a rounded to the size of the bit
BTW anyone know a place to get good endmills (Do-All)
thx