Pro/Forums - View Single Post

Nick C · 12-06-2002, 11:41 AM

hey all

I was wondering about setting a dual pump system up.

would have them in series be better? I'd think not since you'de only get a small water speed increase over the first pump from the second pump

If you ran them in parrallel, and had them both feed a 1 inch PVC pipe system (I plan to put one in my system so the hoses aren't so in the way) woudn't you get a better results?

also
If you have two un-equal pumps (say, an ehim 1048 and a maxi-jet 1200) and ran them in series, would you want the smaller pump first?

thnx
-,e

PS another question

I've got my 1/16 mill bits, and I want to know at what RPMs I should run them at AND at what feedrate I should run them at

thanks again

12-06-2002, 11:41 AM	#1
Nick C Cooling Neophyte Join Date: Sep 2002 Location: OREGON Posts: 62	dual pump setup hey all I was wondering about setting a dual pump system up. would have them in series be better? I'd think not since you'de only get a small water speed increase over the first pump from the second pump If you ran them in parrallel, and had them both feed a 1 inch PVC pipe system (I plan to put one in my system so the hoses aren't so in the way) woudn't you get a better results? also If you have two un-equal pumps (say, an ehim 1048 and a maxi-jet 1200) and ran them in series, would you want the smaller pump first? thnx -,e PS another question I've got my 1/16 mill bits, and I want to know at what RPMs I should run them at AND at what feedrate I should run them at thanks again