Found the problem: A surface mount component got knocked off when I used vise grips to unstick some Gooped on swiftech standoffs. I was sure this was a big deal, but after desoldering another "LA" labeled component and measuring 0 ohms resistance I just jumpered the two pads. The Epox seems to work just fine again now. Huzzah!
I will maybe get a chance to mess around some tomorrow with the testing. A quick first article and then some cross testing with one of Bill's blocks.
Oh and I redid the res on my new system:
http://www.procooling.com/~phaestus/ttcase2.jpg
In fact, it will end up even difft from that.