Quote:
Originally posted by MadDogMe
Would'nt it be better to tilt/spin the HC over 45% on its axis, so that the barb is level with the pump inlet?, the other two barbs would be placed better for routing to the CPU/ect, if you do you might have to resolder the barbs though cause they are at a funny angle though...
Fans look OK to me...
|
Hmmmm, not sure what you are talking about. The two barbs that are side by side on the far right go to the three barb W/B. The barb that is pointing upwards is for filling and bleeding air from the system. On the top of the pump this barb will go to the center barb on the W/B.
The fans are not right and were only placed on the heater core to take photos. The entire system needs to be taken apart for final polishing and sealing of the brass so it will not tarnish.