Pro/Forums - View Single Post

spinky · 12-21-2002, 04:50 AM

okay i need help.

i reinstalled my block twice..didnt help
i dont know the water tempreture, but its not hot to touch.
the waterblock is not hot to touch.

so
im assuming the block isn't seated right.
now

the maze3 block uses the 4 mounting holes, plus nuts to lock it in to place.

i did it with the board in the tower and the case straight..so basically i mount it sideways in...is that the issue?

im suppose to put it laying on its back and install the block?

and one more thing, am i supposed to tighten the nuts to the max? and make the springs all tight? cause if you tighten the nuts to the max, the plastic bolt will go sideways or slant (not straight when tightened too much)

am i doing this wrong? 52C.. pfft.. thats sorta gay.
tempreture outside is 33C, inside my room its lot less than that (aircond)..and it does 52C ..my sk6 before that did 56C on load..

EDIT: first time install, i used a copper shim. 2nd time i reinstall..removed the shim..no diffrence.

12-21-2002, 04:50 AM	#1
spinky Cooling Neophyte Join Date: Oct 2002 Location: Malaysia Posts: 48	52C full load maze3? what the!@#? okay i need help. i reinstalled my block twice..didnt help i dont know the water tempreture, but its not hot to touch. the waterblock is not hot to touch. so im assuming the block isn't seated right. now the maze3 block uses the 4 mounting holes, plus nuts to lock it in to place. i did it with the board in the tower and the case straight..so basically i mount it sideways in...is that the issue? im suppose to put it laying on its back and install the block? and one more thing, am i supposed to tighten the nuts to the max? and make the springs all tight? cause if you tighten the nuts to the max, the plastic bolt will go sideways or slant (not straight when tightened too much) am i doing this wrong? 52C.. pfft.. thats sorta gay. tempreture outside is 33C, inside my room its lot less than that (aircond)..and it does 52C ..my sk6 before that did 56C on load.. EDIT: first time install, i used a copper shim. 2nd time i reinstall..removed the shim..no diffrence.