My thoughts.
1) The airflow through the rad is severly blocked and looks to also be recycling the already warmed air.
2) The pump is sitting in the resivore. Depending on the heat that pump puts off it could be boosting the water temps significantly, especially being the rad air flow is hampered and not cooling effectivly.
3) Make sure the block is evenly tightened down on all 4 corners and it isn't sitting on the high spot of the socket. This should easily be viewable without any tools as the line you will see if it is sitting ontop of the hump will be at the bottom of the block (i.e. you would be able to slide something under the block), or the line will be on the side of the block if seated properly (i.e. you could not slide anything under the block, but you could slide something in between the socket hump and the block). Hard to explain with out pics but I think you get the idea.
Thats about all I got and it has already been covered.
|