Quote:
Originally posted by pippin88
I'm seriously considering making one of these blocks.
However seeing as I have a Mill I would simply mill the area out side about 3-4cm square around the core to allow easy flow.
Now making it with a mill:
I can either drill all the holes and then join with a smallish bit. Or I could just make a crossgrid of channels?
Any ideas for a good Milled version?
I'll whip up a pic actually.
|
Why not just set up a drill cycle with an overlapping hole pattern? That would take care of the channels. You can vary the size of the channels by varying the amount of overlap.
Just be sure to use a short, stiff drill bit!
Bob