Quote:
Originally posted by utabintarbo
Why not just set up a drill cycle with an overlapping hole pattern? That would take care of the channels. You can vary the size of the channels by varying the amount of overlap.
Just be sure to use a short, stiff drill bit!
Bob
|
I don't get ya.
I presume by Drill Cycle you are refferring to CNC, which I dont have (Unless its part of my mysterious extra Christmas present from my dad)
As for doing it by drill, is there any advantage over just having many little pins? Or would I just be best to make a Cathar style block?
I believe the drill and small achannel design came about because of the way of manufacture, not necessarily a series of joined drilled holes having better performance than many channels crossing, to form many pins.