Pro/Forums - View Single Post

pippin88 · 12-26-2002, 12:29 AM

I'll be trying to line up the pump so it lines up better, hopefully only one elbow on the Outlet side, and a straght run to the 3 taps.

Im going to grab a PVC or Copper elbow (Probably PVE due to cost of copper) and goop it onto the pump intake. I'll cap off the other end and glue a barb/spigot into it. This is if I cant get the fiddling with the pump right.

Would it be better to use a short lenght of PVC on the pump, so that the Inlet is not resticted by anything?

Also I popped down to the truck shop down the road. They wanted $10 ($5 US) for a little 45° male - female adaptor. (Was going to put on GPU block

12-26-2002, 12:29 AM	#26
pippin88 Cooling Savant Join Date: Oct 2002 Location: Australia Posts: 285	I'll be trying to line up the pump so it lines up better, hopefully only one elbow on the Outlet side, and a straght run to the 3 taps. Im going to grab a PVC or Copper elbow (Probably PVE due to cost of copper) and goop it onto the pump intake. I'll cap off the other end and glue a barb/spigot into it. This is if I cant get the fiddling with the pump right. Would it be better to use a short lenght of PVC on the pump, so that the Inlet is not resticted by anything? Also I popped down to the truck shop down the road. They wanted $10 ($5 US) for a little 45° male - female adaptor. (Was going to put on GPU block