Here is my take:
Lap your water block down to under 1200 grit. This is possibly issue #1.
Use just enough AS3 to give your block and CPU a sparkly look, but don't goop it on. I would suspect your joint is bad.
Also, check your thermistor and see if it's pushing against the CPU. If it is free floating, then the air under the die gets really hot since there is no circulation. Naturally, you'll get horrendous readings.
Check your lapping, though, and don't use too much goop!!!!!!!
__________________
#!/bin/sh {who;} {last;} {pause;} {grep;} {touch;} {unzip;} mount /dev/girl -t {wet;} {fsck;} {fsck;} {fsck;} {fsck;} echo yes yes yes {yes;} umount {/dev/girl;zip;} rm -rf {wet.spot;} {sleep;} finger: permission denied
|