Quote:
Originally posted by lukasz70
thanks for the offer petDMC, i've somewhat solved my barb problem, i "Bought" a 1in bard but the thread is a bit smaller, it still screws and stays in, but its loose when screwing it in, i'll use that one for the output, wrap it with tephlon, and put a seal under it and it should do well, as for the input, i will go with the original 5/8 barb and hose b/c they will hook up to the res anyway,
but with one problem solved, i've run into another, my res will be attached to the back with a barb at the bottom going through the case an into the pump. my pump is in the back of the case, if i use a barb on the res and pump, they will get in each others way and i cant connect them , b/c of the HC, the pump has to be right behind the HC that gives me maybe 2 inches with the barb on the pump to the back wall of the case
|
thats cool
lol u and me are in the same boat, i'm trying to figure out how to connect the pump and the res (this is where making your own stuff comes in handy and also being able to use a machine shop
)
heres my idea
get a 5/8 barb and a washer or 2 that fits it
cut the connector off (so u just have the threaded piece)
the drill a hole of that size in the res
put a washer on it, then put it throught the hole that u just drilled
put some sealent (or if you want you could just tap the res so the barb screws in) the place another washer on the other end
then just screw it into the pump inlet
i hope u can understand what i mean
