[Banshee164]

Just put in a new maze3 - 3/8" with the socket hold down, getting 45-46c at full load. I was getting around 42-43c with my maze1 - 3/8". I tried increasing the pressure on the hold down but it didn't help. The block is sitting flat on the die as far as I can tell, not using a shim on the cpu. Only other thing that changed is that I switched cases from a mid tower to a full one so now the radiator is at the top as opposed to in front on the bottom. Could the decreased flow rate due to the height/tubing length cause the difference or maybe the block just needs to be lapped? Pump is a Eheim 1048 with a BI pro rad. Thanks for helping