Nick C, fair enough question. I've just recently started looking into WC as a solution. I have available to me plenty of machining equipment that making it is not a problem. The design part is not either (i will probably ask some stupid questions though in the near future) i will do that in autocad 2k2 then post the gcode out and machine it myself. I guess the main reason for me asking was because i readily have aluminum to do the project at nearly no cost, however copper is a different story. I guess i'm being a bit cheap on the whole thing and was more curious if i am going to toast my cpu or gpu if i design a waterblock for them and run from aluminum rather than copper. if you have any more questions about what i'm planning please ask and i hope this helps clear up my question.
|