Pro/Forums - View Single Post

jaydee · 12-30-2002, 07:54 PM

here is the CAD drawing for anyone who is interested. I will see if I can attach it for download.

The yellow is basically what the channles will look like after milling. The white lines are the tool paths. Disregard the green circles as I don't think they are in the right spot for mounting. They might be but I can't remember.

Also here are a few close up pics. The outer chanhnel is 3/8" wide and deep. The pins are only 3/16" tall and go all the way to the top of the block and make contact with the top peice and they are sitting on a 3/16" base. The material is 1/2" thick by 2" wide by 3" long.

I been wanting to make one out of Copper but havn't got around to it. I think the pins would be more usefull as copper should be able to transfer the heat more effectivly than AL. but it does work good for mw the way it is.

12-30-2002, 07:54 PM	#14
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	here is the CAD drawing for anyone who is interested. I will see if I can attach it for download. The yellow is basically what the channles will look like after milling. The white lines are the tool paths. Disregard the green circles as I don't think they are in the right spot for mounting. They might be but I can't remember. Also here are a few close up pics. The outer chanhnel is 3/8" wide and deep. The pins are only 3/16" tall and go all the way to the top of the block and make contact with the top peice and they are sitting on a 3/16" base. The material is 1/2" thick by 2" wide by 3" long. I been wanting to make one out of Copper but havn't got around to it. I think the pins would be more usefull as copper should be able to transfer the heat more effectivly than AL. but it does work good for mw the way it is.