Pro/Forums - View Single Post

bigben2k · 01-02-2003, 09:33 AM

I think that the general consensus (?) is that it's hard to do, because you DO want to keep the curvature in it (because it straightens up under clamping) but the nickel (?) plating needs to come off, exposing copper.

I'd buff the surface metal off, but most would tell you that it will affect the flatness.

01-02-2003, 09:33 AM	#2
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	I think that the general consensus (?) is that it's hard to do, because you DO want to keep the curvature in it (because it straightens up under clamping) but the nickel (?) plating needs to come off, exposing copper. I'd buff the surface metal off, but most would tell you that it will affect the flatness. __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101