I'm thinking of doing a small write-up about this, but i'll give you some insight as to how I went about this. I got 4 bolts. Mine were 1/4", but that was a tight fit. Try to grab something SLIGHTLY skinnier. Stick those through the holes so they stick up, and put some material under the nut on the back of the mobo in order to prevent a mobo shortage. Then grab a piece of plywood 3"x3". Drill holes for the bolts.If you are using an H2O block w/ straight fittings, you are good to go. If you have elbow fittings as most of us do, you will have to saw away some of the wood where the fittings come up. Hope that helps
Quote:
Originally posted by Highvoltagepc:
Kevin:do you know if any one has that has these premade?or do you have an idea you would share?...thanx
The best are the ones where you use the four holes around the socket A. That's what did...
|
[This message has been edited by Highvoltagepc (edited 11-26-2000).][/quote]