Pro/Forums - View Single Post

Ion · 01-05-2003, 12:42 PM

Bought an Opel Kadett Heatercore. The cooling area is 16 cm wide, 18 cm high. 6,35" x 7,14" that is. My problem is fitting this thing into my Antec SX630 (Chieftec? Who knows...), that is the smaller Antec without the door, but rather the same design, 3 CD-ROM slots, one 3,5".
The Heatercore isn't too big, but the pipes/fittings are the problem. The look like this, rather than like this. You see? Those periscope like things make the HC too high. Should I drill holes for them through my floppy =) or should I cut them off and put some nice fittings facing the right direction on the tanks instead?
Thanks for your advice.

01-05-2003, 12:42 PM	#1
Ion Cooling Neophyte Join Date: Sep 2002 Location: Sweden Posts: 66	Opel Kadett Heatercore Bought an Opel Kadett Heatercore. The cooling area is 16 cm wide, 18 cm high. 6,35" x 7,14" that is. My problem is fitting this thing into my Antec SX630 (Chieftec? Who knows...), that is the smaller Antec without the door, but rather the same design, 3 CD-ROM slots, one 3,5". The Heatercore isn't too big, but the pipes/fittings are the problem. The look like this, rather than like this. You see? Those periscope like things make the HC too high. Should I drill holes for them through my floppy =) or should I cut them off and put some nice fittings facing the right direction on the tanks instead? Thanks for your advice.