Pro/Forums - View Single Post

Jscamry · 01-06-2003, 04:34 PM

hey all i just ordered wattering cooling prodcuts for myself for x-mas. I purchased a hydor L30 320gph, Maze 3 luctie top, 10 ft of clear clear flex tubbing. I bought heatercore from a local autoparts store, its 6x6x2, I also made a shroud w/ a 120mm fan pulling air through the hc. The order my setup follows is pump-> WB->HC->Res->pump.

My comp contains Asus A7m266, AMD xp 1800, 300W generic power supply, 2 sticks of pc2100 256mb, abit siluro Geforce 4 MX440, western digital 100gig HDD, 3com adsl modem and a nic. and two rear exhaust fans
my temps are 47c just surfing the net, when i started the comp and pump from a cold start the temps were 34c.yeah my room is about 80-85f and i am not sure about the case temps. I am using the asus pc probe to find out my proc temps. yes i have done a stress test w/ prime 95 for a few hrs it gets to about 51c.

I have taken the setup apart many times to check that the wb is seated properly, i have also applied AS the way the web site suggest, i even tried to apply a thicker coat of AS the the proc. I have added 1 oz of watter wetter.

thanks all any help would be appc..

01-06-2003, 04:34 PM	#1
Jscamry Registered User Join Date: Dec 2002 Location: Oviedo,Fl Posts: 6	maze 3 bad temps hey all i just ordered wattering cooling prodcuts for myself for x-mas. I purchased a hydor L30 320gph, Maze 3 luctie top, 10 ft of clear clear flex tubbing. I bought heatercore from a local autoparts store, its 6x6x2, I also made a shroud w/ a 120mm fan pulling air through the hc. The order my setup follows is pump-> WB->HC->Res->pump. My comp contains Asus A7m266, AMD xp 1800, 300W generic power supply, 2 sticks of pc2100 256mb, abit siluro Geforce 4 MX440, western digital 100gig HDD, 3com adsl modem and a nic. and two rear exhaust fans my temps are 47c just surfing the net, when i started the comp and pump from a cold start the temps were 34c.yeah my room is about 80-85f and i am not sure about the case temps. I am using the asus pc probe to find out my proc temps. yes i have done a stress test w/ prime 95 for a few hrs it gets to about 51c. I have taken the setup apart many times to check that the wb is seated properly, i have also applied AS the way the web site suggest, i even tried to apply a thicker coat of AS the the proc. I have added 1 oz of watter wetter. thanks all any help would be appc..