ok, been doing some more digging and have come up with a few more things, so i have lots of questions. First off where i'm at currently the oil's in the tranformers still have bad bad things in them they are looking at changing that out so i'll have to wait to see about that oil. As for oil's i have found, there is a way oil that is used in machining that i am going to try, but first i have a friend who runs a screw machine shop. they use a very fine oil there for this exact purpose, and lubricant too i am going to try that first. However i am curious if i should do any modification's to the block i will be using, it's made in a similar fashion to this one
http://forums.procooling.com/vbb/sho...&threadid=5208
since i will be using an oil instead of a water mixture should i underclock the cpu first?
should i make any mod's to the fins also taller/shorter?
and anything else anyone might be able to think up would be appreciated too.