Quote:
Originally posted by hara
I assumed the core is all heating the same. I placed the thin base exactly on the centre because heat it is surrounded by heat. It's in the middle of the heat source. The reality is that half the area of the cpu core is L2 cache which doesn't produce much heat but anyways... I'll start researching where to machine it cause I'm sure it's a bitch.
I thought about a compination of thorns, mills and drill presses. What do you think?
|
Well a Mill can be used as a drill press. I m not sure what could be drilled though exept the barb holes and screw holes but if this is going to be done by a shop it would be better to have them do it with the mill. These small channels will be a pain, but they are strait so that is a bonus. I was impressed that morphin1 pulled it off so nicely with his mill. I would ask him what it took. I think you will have a good block here in any event.